Bug Reports
INT snapping doesn't work in 2018.3

New project, create a couple of planes, a circle, and a line, making sure they intersect. Grab the line tool, set INT snapping, and try to snap to intersected lines. I re-installed 2018.1 and it worked fine. Then re-installed 2018.3 again and it didn't work. All the other snap types work fine.

New project, create a couple of planes, a circle, and a line, making sure they intersect. Grab the line tool, set INT snapping, and try to snap to intersected lines. I re-installed 2018.1 and it worked fine. Then re-installed 2018.3 again and it didn't work. All the other snap types work fine.
10
0
1
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft