LwCad for LightWave
Spiral Stairs

It seems that with a spiral staircase greater than 360° the railings (or the curve associated with it) is not drawn greater that 360°. It draws the railing/curve evenly spaced between the top and bottom stairs but not the full length of the stairs.

It seems that with a spiral staircase greater than 360° the railings (or the curve associated with it) is not drawn greater that 360°. It draws the railing/curve evenly spaced between the top and bottom stairs but not the full length of the stairs.

Something to update...When I get to 720°, the railings complete both 360s but if I do 721° or 359° the railing is as before (somewhere between the top and bottom).

Something to update...When I get to 720°, the railings complete both 360s but if I do 721° or 359° the railing is as before (somewhere between the top and bottom).
13
1
1
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft