Codoforum Related Descussions
On my form using CODOLOGIC forum.

When you use the move snap tool with cloning, you can't adjust the height of the clone.

Steps

Create a box with the box tool
Us the move snap tool
Press "n" on the keyboard to open the numeric panel
Turn on cloning
Clone your object going down from the top viewport
Now go over to the Right viewport
Try clicking on the handle to make your clones go upwards or step
The orange arrow moves but not the clones. (See image below)

This worked in LWCAD versions 4.51 (Vector Clone) Vector Clone was replaced with Move Snap Cloning in version 5.2

VIDEO LINK BELOW

https://www.facebook.com/jason.boudreau.946/videos/10158237967340641/

Thanks
Jason

When you use the move snap tool with cloning, you can't adjust the height of the clone. Steps Create a box with the box tool Us the move snap tool Press "n" on the keyboard to open the numeric panel Turn on cloning Clone your object going down from the top viewport Now go over to the Right viewport Try clicking on the handle to make your clones go upwards or step The orange arrow moves but not the clones. (See image below) This worked in LWCAD versions 4.51 (Vector Clone) Vector Clone was replaced with Move Snap Cloning in version 5.2 VIDEO LINK BELOW https://www.facebook.com/jason.boudreau.946/videos/10158237967340641/ Thanks Jason

22
0
1
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft