Crash when executing a SUB operation using the Line tool (crash report sent to NewTek)
1 - Create a simple cube with the Box tool
2 - From e.g. the Top view, enable the LWCAD Line tool, set mode to SUB
3 - LCLICK outside the mesh to establish the UCS plane and starting point
4 - LCLICK outside the mesh to e.g. cut off a corner of the cube
(crash)
LW Modeler: 2018.0.2, build 3065, Windows 10 1709, 16299.309
(MORE INFO) This also causes a crash with 2015.3. If Polygon mode is enabled and a 3 or more point shape is created to encompass the area to be cut, that works. Maybe I'm forgetting how this should work -- but of course a crash is never right...
Crash when executing a SUB operation using the Line tool (crash report sent to NewTek)
1 - Create a simple cube with the Box tool
2 - From e.g. the Top view, enable the LWCAD Line tool, set mode to SUB
3 - LCLICK outside the mesh to establish the UCS plane and starting point
4 - LCLICK outside the mesh to e.g. cut off a corner of the cube
(crash)
LW Modeler: 2018.0.2, build 3065, Windows 10 1709, 16299.309
(MORE INFO) This also causes a crash with 2015.3. If Polygon mode is enabled and a 3 or more point shape is created to encompass the area to be cut, that works. Maybe I'm forgetting how this should work -- but of course a crash is never right...
edited Mar 27 '18 at 2:22 am
