LWCAD general
Request for Road lines tool

I would like to request an addition of controls for the second dash or line.

As of now you can only do dash + solid line, and it doesn't accomplish what I require; short dash and long dash.

The short and long dash next to each other is standard markings in, or through curves to signal that it is unsafe to overtake on that stretch of road.

Solid line is seldom, if ever, used for such. Most likely double lines, which is already possible to do.

So to be clear; I would like to be able to control both Line 1 and Line 2 individually with all the controls you already have for Line 1.

I would like to request an addition of controls for the second dash or line. As of now you can only do dash + solid line, and it doesn't accomplish what I require; short dash and long dash. The short and long dash next to each other is standard markings in, or through curves to signal that it is unsafe to overtake on that stretch of road. Solid line is seldom, if ever, used for such. Most likely double lines, which is already possible to do. So to be clear; I would like to be able to control both Line 1 and Line 2 individually with all the controls you already have for Line 1.
9
0
1
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft