LwCad for LightWave
Curves to Surface?

Hi.

I have two curves for an O letter, one for the outside and the other for the inside. I want to know if I can turn those curves into a NURBS flat surface with a hole. The Legacy Curves to Surface button doesn't do anything.

Hi. I have two curves for an O letter, one for the outside and the other for the inside. I want to know if I can turn those curves into a NURBS flat surface with a hole. The Legacy Curves to Surface button doesn't do anything.

Flat Patch tool is the best way.
Be sure those curves are LWCAD curves.
If not you have to convert them to NURBS curves first.

Flat Patch tool is the best way. Be sure those curves are LWCAD curves. If not you have to convert them to NURBS curves first.

Viktor Veličko, WTools3D founder

50
1
2
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Pending draft ... Click to resume editing
Discard draft