LwCad for LightWave
Arc Tool produces unexpected results in some situations
arctool arc

I already reported this issue, but if somebody could confirm.
When creating an arc from 3 points of an existing circle, the result is a straight line. All is fine as long as the 3rd point is near a point from the circle, but once it's on the point, the arc becomes a straight line.
This happens with any circle object (LW2020.03/LWCAD 2023.00).

I already reported this issue, but if somebody could confirm. When creating an arc from 3 points of an existing circle, the result is a straight line. All is fine as long as the 3rd point is near a point from the circle, but once it's on the point, the arc becomes a straight line. This happens with any circle object (LW2020.03/LWCAD 2023.00).
10
0
1
live preview
enter atleast 10 characters
WARNING: You mentioned %MENTIONS%, but they cannot see this message and will not be notified
Saving...
Saved
With selected deselect posts show selected posts
All posts under this topic will be deleted ?
Cancel
Delete
Pending draft ... Click to resume editing
Discard draft